mirror of
https://github.com/ChuckBuilds/LEDMatrix.git
synced 2026-10-04 14:25:08 +00:00
ChuckandClaude Opus 5
6031e70525
Two problems, both found by looking at the panel rather than the metric.
The frame-stats line reported ONE instantaneous frame every 5 seconds --
about 1 frame in 500 -- printed beside a 100-frame average. Both hide exactly
the fault they are used to chase: a 2ms duplicate and a 21ms double-wait
average to precisely 10ms, so a ticker stalling on half its frames still
reports a healthy "Avg FPS: 100.0". That reading cost several rounds of
chasing the wrong layer. The line now aggregates every frame since the last
log and reports median, p95, max, min, and explicit stall and skip rates
(past 1.5x the median missed a refresh; under half never reached the panel,
because dirty tracking skipped the swap so the frame never waited on vsync).
On the hardware this now reads:
leaderboard 100.0 fps over 501 frames | median 10.00ms p95 10.05ms
max 10.34ms | stalls 0 (0.0%) skips 0 (0.0%)
The binding rebuild's blit patch becomes opt-in (RGB_PATCH_BLIT=1, default
off). Reordering that loop to row-major changes what a torn frame looks like:
column-major tearing shows as a vertical seam, row-major as a horizontal split
between the panel's upper and lower halves. On a 1/32 scan panel that reads as
a one-pixel fold across the middle of every panel, which is what was reported
on hardware and what went away when the blit was reverted. All of the measured
gain comes from the SwapOnVSync change, so the risky half is simply not worth
taking; the header says so.
Also fixes --install resolving its paths against $HOME, which is /root under
sudo, so it looked in /root/rgbmatrix-nogil-build and died with "no built
module found" on a machine where the build had just succeeded. It now resolves
SUDO_USER's home. Both build paths are verified on the Pi: default yields one
GIL-release site, RGB_PATCH_BLIT=1 yields two.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>