You're connected to the LEDMatrix-Setup network. Configure your WiFi connection below to connect to your home network.

WiFi Setup

Configure WiFi connection for your Raspberry Pi. Access point mode will automatically activate when no WiFi connection is detected.

Connection:

Network:

IP Address:

Signal:

AP Mode:

Step 1: Select Network

( networks)

Scan for available networks or manually enter SSID below.

Selected:

Or Enter SSID Manually

Step 2: Enter Password

Enter the WiFi password. Leave empty if the network is open (no password required).

Access point mode allows you to connect to the Raspberry Pi even when it's not connected to WiFi.

Auto-Enable AP Mode

When enabled, AP mode will automatically activate when both WiFi and Ethernet are disconnected. When disabled, AP mode must be manually enabled.